Epson Y16499100301 - Manual (Page 85)

If the plug has retaining screws, tighten them with a
screwdriver.
5. If necessary, plug the monitor’s power cable first into the
power inlet on the monitor. (Some monitors come with
permanently attached power cables.) Then plug the power
cable into an electrical outlet.
6. Turn off DIP switch 4 above the keyboard to let the
computer know you will be using a monitor instead of the
LCD screen. (See “Setting the DIP Switches” in Chapter 1.)
When you are ready to use the computer, turn on the
monitor and any other peripherals, and then turn on the
computer. Text will be displayed on the monitor screen instead
of the computer screen.
Replacing the Backlit Screen Element
If you need to replace the electroluminescent element in the
backlit screen, follow the instructions below. The procedure has
many steps, but they are not difficult. Still, you must be very
careful not to damage any components on or inside the screen.
If you have any reservations about doing this yourself, ask your
dealer to install it for you.
1. Turn off all peripherals and the computer before you begin.
2. Use a flat blade screwdriver to remove the plastic tops of
the brightness and contrast switches.
A-2
Options and Maintenance