beautypg.com

Warning this, User’s guide, Fcc compliance statement for american users – Epson Y16499100301 User Manual

Page 6

background image

FCC COMPLIANCE STATEMENT

FOR AMERICAN USERS

This equipment generates and uses radio frequency energy and if not installed

and used properly, that is, in strict accordance with the manufacturer’s instruc-

tions, may cause interference to radio and television reception. It has been type

tested and found to comply with the limits for a Class B computing device in
accordance with the specifications in Subpart J of Part 15 of FCC rules, which

are designed to provide reasonable protection against such interference in a residen-
tial installation. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:

l

Reorient the receiving antenna

l

Relocate the computer with respect to the receiver

l

Move the computer away from the receiver

l

Plug the computer into a different outlet so that the computer and

receiver are on different branch circuits.

If necessary, the user should consult the dealer or an experienced radio/televi-
sion technician for additional suggestions. The user may find the following book-

let prepared by the Federal Communications Commission helpful:

“Television Interference Handbook”

This booklet is available from the U.S. Government Printing Office, Washing-
ton DC 20402. Stock No. 0044-000-00450-7.

Note:

If the interference stops, it was probably caused by the computer or its

peripheral devices. To further isolate the problem:

Disconnect the peripheral devices and their input/output cables one at

a time. If the interference stops, it is caused by either the peripheral device

or its I/O cable. These devices usually require shielded I/O cables. For

Epson peripheral devices, you can obtain the proper shielded cable from
your dealer. For non-Epson peripheral devices contact the manufacturer

or dealer for assistance.

WARNING

This

equipment has been certified to comply with the limits for

a Class B computing device, pursuant to Subpart J of Part 15 of

FCC Rules. Only peripherals (computer input/output devices, ter-

minals, printers, etc.) certified to comply with the Class B limits

may be attached to this computer. Operation with non-certified

peripherals is likely to result in interference to radio and TV

reception.

The connection of a non-shielded equipment interface cable to this

equipment will invalidate the FCC Certification of this device and

may cause interference levels which exceed the limits established

by the FCC for this equipment.

User’s Guide