Ericsson A1228di - Manual (Page 18)

Not
for
commercial
use
– Ericsson
Inc.
%DVLF 2SHUDWLRQV
7HPSRUDULO\ 0XWLQJ WKH 5LQJ 7RQH
To temporarily mute the ring tone without answering the call, press
12 or the upper or lower side volume key. Incoming Call is still
shown in the display, and you can still answer the call by pressing
<(6 .
&DOOHU 1XPEHU ,GHQWLILFDWLRQ
If your service provider has Caller Number Identification (Caller ID)
service, your phone shows the phone number of an incoming call in
the display. If the number is one that you have stored in your
phonebook with a name, the name is shown when your phone rings.
If the Caller ID information is not available, the message NO ID is
shown in the display. The word Anonymous may be shown if the
Caller ID is restricted by the service provider or by the caller.
0XWLQJ WKH 0LFURSKRQH 'XULQJ D &DOO
To mute the microphone during a call, press and hold the &/5 key.
Mic Muted appears in the display when the call is muted. Repeat
this procedure to return to your call.
,QFUHDVLQJ RU 'HFUHDVLQJ (DU 9ROXPH 'XULQJ D &DOO
Use the following instructions to increase or decrease ear volume
during a call:
• To increase the ear volume during a
call, press the upper key on the side of
your phone.
• To decrease the ear volume during a
call, press the lower key on the side of
your phone.
/RZ %DWWHU\ 3RZHU $OHUW
The low battery alert sounds when your battery is reaching its lowest
operational power level. The words Low Battery! will appear in
the display. When this happens, leave your phone turned on. The
phone discharges the battery and then automatically turns off.
Charge the battery within 24 hours after a complete discharge so
that the battery can charge to full capacity.
6HWWLQJ WKH 'LVSOD\ /DQJXDJH
You can set the language used to display the menus for your mobile
phone. To change the display language:
1 Press 0(18 from the Standby screen to access the main menu.
2 Press to display the SETTINGS menu.
3 Press to display the Language submenu.
4 Press the or repeatedly until the appropriate language option
is highlighted. The language options are English, French, Spanish,
Portuguese, Hebrew, or Russian (languages may vary by region).
5 Press <(6 to select the Language.
6 Press 12 to return to the previous screen or press &/5 to return to
the Standby screen.
Note! If you accidentally select the wrong language, press 0(18 and
scroll to the correct language.
'LWWR /LQGDERRN 3DJH 7XHVGD\ 2FWREHU 30