Emulex Printer Server - Manual (Page 47)

Command Reference Guide 41
put Use this keyword when the environment does
not support BootP, DHCP, or TFTP server load
requests to a printer server.
decnet Upon reinitialization, the printer server
downloads its operational software from a
network load host using standard decnet-
compatible load protocol. The default is dec.
Power must by cycled after this command is performed.
Define Software File Name
Specify the file name of the file on a load host that contains the printer
server’s operational software.
>
Server>> define server software file_name
file_name Enter the name of the file that contains the
printer server’s operational software. For
DECnet load hosts, this is a 1 to 9 character file
name. For TFTP load hosts, this is a 1 to 16
character file name. See the chart below for
DECnet and TFTP file names:
Printer Server TFTP DECnet
NETJet NJATLNE NJATLNE.SYS
NETQue NQATLNE NQATLNE.SYS
Token Ring NQTTLNE NQTTLNE.SYE
NETQue Mate NQMTLNE NQMTLNE.SYS
NETQue Pro2 NP2TLNE NP2TLNE.SYS
Set Load/Dump Gateway
Specify the IP address of the gateway through which the printer server
loads and dumps its internal software.
>
Server>> define server gateway [load_dump] ip
[ip_address |none]
load_dump Enter the gateway through which the printer
server loads and dumps its internal software.
The printer server maintains only one gateway