Emulex Printer Server - Manual (Page 31)

Command Reference Guide 25
Set Prompt
Specify the prompt displayed when the printer server is in local mode
and awaiting a printer server command.
>
Server>> set server prompt “prompt”
“prompt” Enter 1 to 8 characters, enclosed in quotes.
The default is “server”. The printer server
always adds the string “>>“ after the prompt in
privileged mode or “>“ when not in privileged
mode. The RCF port will always display Local>.
Modify SNMP
Add or modify entries in the SNMP table or change the printer server’s
SNMP trap host IP address.
>
Server>> [set |define |change] server snmp
com_name
access acc_right [trap IP ip_addr]
[set] [enabled |disabled]]
com_name The name of an SNMP community.
acc_right Specifies access privileges associated with the
community name: read, write, or read/write.
trap Establishes a trap host to receive messages
from the printer server.
ip_address Enter the IP address for the workstation that will
receive SNMP trap messages from the printer
server. The IP address must be entered in
decimal dot notation. For example,
123.234.345.490. The
set Allows an SNMP manager to perform set type
operations on the printer server.
enabled If enabled, SNMP set requests will be accepted.
disabled If disabled, SNMP set requests will be rejected.