Exmark Metro - Manual (Page 24)

- 19 -
4.3 OPERATING INSTRUCTIONS
4.3.1 Read the Engine Owner's Manual carefully for detailed operating instructions and
maintenance regarding the engine.
Before attempting to operate the unit, refer to Section 1 (Safety) and follow all
safety, operating, and preparation guidelines as stated in that section.
4.3.2 Starting Engine
Position mower on a level surface. Disengage blade drive and place transmission
in neutral.
Open fuel shut-off valve.
NOTE: Always engage the left and right neutral lock/park brake
latches in the “park brake” position when starting the
engine (See Section 4.1.3).
WARNING
POTENTIAL HAZARD
♦ Engine exhaust contains carbon monoxide, which is
an odorless deadly poison.
WHAT CAN HAPPEN
♦ Carbon monoxide can kill you and is also known to the
State of California to cause birth defects.
HOW TO AVOID THE HAZARD
♦ Do not run engine indoors or in a small confined area
where dangerous carbon monoxide fumes can collect.
With a cold engine place the throttle in the full "choke" position. For 15 & 17 HP
Kawasaki units turn the key switch to the “Run” position. With a warm engine,
place the throttle midway between the "slow" and "fast" position.
NOTE: Kawasaki engines generally need to be "choked" even when warm.
Pull recoil rope to start engine. After engine starts, move throttle control out of the
choke position.
4.3.3 Stopping Engine:
Disengage blade drive, shift transmission to neutral and lock the drive levers in
“park brake” position. Move throttle to "slow" position.
Allow engine to idle for 30 seconds to allow cool down then:
For 12.5 HP Kawasaki, Kohler, and 10.5 HP B&S engines: Move throttle to full
rear position to stop the engine.
For 15 & 17 HP Kawasaki engines: Turn the key to the “Off” position
Close fuel shut-off valve if machine will not be used for a few days; when parking
inside a building; or when transporting the unit.