Extron electronic MDA 2V EQ - Manual (Page 3)

VersaTools® MDA EQ Series • Quick Start Guide
Quick Start Guide — MDA EQ Series
To install and set up an MDA EQ Series mini distribution
amplifier, follow these steps:
Step 1
Turn all of the equipment off and disconnect it from the power
source.
Step 2
Mount the MDA EQ on a projector, under a desktop, or on a rack
shelf, as illustrated below. (The illustration shows a VersaTools®
rack shelf; you can also use the standard or 6-inch deep Universal
19-inch rack shelves. See Optional Accessories in appendix A.)
Step 3
Wire the MDA EQ power cord and connect it. To wire the power
cord, follow these steps, and refer to the illustration on the next page.
a . Cut the DC output cord to the length needed.
b . Strip the jacket to expose 0.2 inches (5 mm) of the
conductors.
c . Slide the leads into the supplied captive screw plug and
lock them, using an Extron Tweeker (small screwdriver).
Ceiling
Projector
Projector
Mounting
Bracket
Mounting
Bolt
(2) 4-40 x 3/16"
Screws
Use 2 mounting holes on
opposite corners.
VersaTools Rack Shelf
1/4 Rack Width Front
False Faceplate
QS-1