Enviro C-10637 - Manual (Page 23)

23
Secondary Installation
R
EMOVING
T
HE
B
RICK
P
ANEL
:
The brick panel set is fragile, handle with extreme care.
The brick panel set comes
pre-installed. The centre and
top panel are the only panels
that need to be removed
if the complete gas and
electrical tray assembly must
be removed. The side panels
may remain installed unless
they are to be replaced.
1. Turn the unit off and allow
the unit to cool completely.
2. Remove the fascia or
louvers, open the door, and
remove the log set.
3. Pull out the bottom of the
centre panel while pushing
up on the top panel.
4. With the center panel out,
the top panel will easily
come out. Just slide the top
edge back out of the top lip
in the firebox.
If the side panels must be
removed, continue with steps
5, 6, and 7.
5. Remove the log support
tray by lifting the back of
the tray up and pull it out
from under the lip. Take
care not to knock the pilot
and the side brick panels.
6. Remove the two (2) T-20
screws holding the bottom
of the baffle (shown in
Figure 33).
7. Pull the panels out of
the lips at the front of
the firebox and carefully
remove the panel from the
unit (shown in Figure 34).
To re-install, follow the above
steps in reverse.
Figure 34: Brick Panel Installation.
Figure 33: Brick Panel Installation.
Figure 32: Brick Panel Installation.