Enviro C-10637 - Manual (Page 13)

Initial Installation
QUALIFIED INSTALLERS ONLY
D
IRECT
V
ENT
M
ODEL
:
WARNING: This appliance has been designed to draw room air for proper heat circulation
from the sides of the unit. Blocking or modifying the louvers in any way can create hazardous
situations.
This model is vented with two (2) 3” aluminum or stainless steel flex vent leading into a co-linear to
co-axial vent adaptor and using a vertical termination cap. The flue collars of this model will fit inside of
standard 3” vent and may be fastened directly to the vent. The Exhaust vent is on the right of the flue
connector. The Air Intake is on the left side of the vent collar plate (this outlet is not in the center, it is off
to one side of the vent collar plate.)
Check periodically that the vents are unrestricted. Also ensure that all direct vent pipes have been
properly sealed and installed after routine inspection or cleaning. The air intake and exhaust pipes must
be installed in the correct locations on the removable connector.
P
REPARING
Y
OUR
S
IENNA
F
OR
I
NSTALLATION
:
• Remove the packaging from the appliance and surround panels; check to make sure there is no
damage. Carefully check the glass door. Do not use the unit if it is damaged. In the event damage is
found, please report it to both the courier and your dealer as soon as possible.
• Carefully clean the fireplace and flue before installing the stove. Failure to do so may result in fumes
or dirt being blown into the room and may cause a fire leading to death or serious injury.
1. Remove the unit from the box and remove all packaging material from the appliance.
2. Remove door. See “D
OOR
R
EMOVAL
”.
3. Remove log and ember set and all wrapping material from the stove. Remove wrapping material from
log and embers and check for any damage. If damage is observed, do not use unit and contact your
local dealer.
4. Remove the vent collar plate from the top of the stove by unscrewing the two (2) T-20 Torx screws
located on the center top of the stove. Slide the collar plate backwards. If the fireplace that the unit
is to be installed into is high, the collar plate does not need to be removed. Properly secure the vent
collar plate to the flexible vent pipe liner(s) previously installed in the chimney. Be careful not to over-
stretch the liner(s).
5. Place the unit part way into the fireplace. Connect the fireplace insert’s flexible gas line to the
household gas supply, using locally approved methods. Place the electric cable so it can be connected
to the power supply.
13
6. As you push the unit into its final position
in the fireplace, if the vent collar plate was
removed, reinstall it to the stove by sliding
it along the draft hood and secure with the
screw.
7. Adjust the leveling legs to ensure the unit
is level. There are two (2) leveling legs on
each side (shown in Figure 11).
Leveling Legs
two (2) on each side
Figure 11: Leveling legs position.