Electrolux EKC607601 - Manual (Page 24)

The rounded ends of the shelf support
rails must point to the front!
Caution! Make sure that the longer
fixing wire is in the front. The ends of
the two wires must point to the rear.
Incorrect installation can cause
damage to the enamel.
CLEANING THE TOP OVEN GLASS
PANELS
The door glass on your product can be
different in type and shape from what
you see in diagrams. The number of
glasses can be different.
Removing the glass:
1. Open the door.
2. Push the door trim at both sides to re-
lease the clips. Refer to the picture.
3. Remove the glass panels.
1
2
1
To replace the glass obey the proce-
dure in opposite sequence.
CLEANING THE DOOR GLASS PANELS
The door glass on your product can be
different in type and shape from what
you see in diagrams. The number of
glasses can be different.
Removing the glass:
1. Push the door trim at one side to re-
move it. Refer to the picture.
2. Pull up the trim.
3. Remove the glass panels.
1
2
A
To replace the glass panels obey the
procedure in opposite sequence. Be-
fore you lower the trim attach the A
trim part to the door. Refer to picture.
OVEN LAMP
Warning! There is a danger of
electrical shock!
Before you change the oven lamp:
• Switch off the oven.
• Remove the fuses in the fuse box or
switch off the circuit breaker.
Put a cloth on the bottom of the oven
for protection of the oven light and
glass cover.
Replacing the oven lamp
1. You can find the lamp glass cover at
the back of the cavity.
Turn the lamp glass cover counter-
clockwise to remove it.
2. Clean the glass cover.
3. Replace the oven lamp with applicable
300°C heat-resistant oven lamp.
Important! Use the same oven lamp type.
4. Install the glass cover.
24 electrolux