Epson 410 User Manual

Page 31

Chapter 4

Designing Labels Using LDS

))))))))))))))))))))))))))))))))))))))))))))

410 Operators Manual

4.3.1 A SAMPLE SESSION WITH A LABEL HEADER

This is the label header from the sample label in section 4.2.

4,615,153,,20,30,,70,4

4 -

4 fields following the header

615 - Label width (LSX) of 615 (615/154= ~4 inches)
153 - Label length (LSY) of 153 (153/154 = ~1 inch)
-

No entry in the WEB parameter means default value of 10

20 -

A GAP between labels of 20 (20/154 = ~.13 inch)

30 -

Label print speed (DPS) of 30 = 2.5 inches per second (from table)

No entry for the LCN parameter means default value of 0, normal stock on
backing paper

70 -

The AGD could not be defaulted because the stock was less than 2.3 inches in
length (LSY). This value was produced from auto-sizing (LDS command ^D39)
the label.

4 -

SPG also could not be defaulted because of the small size of the stock. Auto-
sizing quickly produced this value.

A carriage return must follow the label header. There were two parameters left

that were not entered into the header - OFX and OFY. Because they were not
entered, the printer assumes the default values, 0 in their cases. Likewise, if the
AGD and SPG were defaulted, the carriage return could have followed the DPS.