Epson 410 - Manual (Page 29)

Chapter 4 Designing Labels Using LDS
))))))))))))))))))))))))))))))))))))))))))))
))))))))))))))))))))))))))))))))))))))))))))
410 Operators Manual 23
See Table 3 for a list of print speeds, DPS values, and inches per second.higher value
slows the printer down and a smaller value speeds it up.
Print Speed
DPS MM/SEC INCHES PER
SECOND
INCHES PER
MINUTE
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40 76.8
74.2
71.7
69.1
66.6
64.0
61.4
58.9
56.3
53.8
51.2
48.6
46.1
43.5
41.0
38.4 3.0
2.9
2.8
2.7
2.6
2.5
2.4
2.3
2.2
2.1
2.0
1.9
1.8
1.7
1.6
1.5 180
174
168
162
156
150
144
138
132
126
120
114
108
102
96
90
Table 4
LCB LABEL CONTROL BYTE
The label control number defines the type of label stock that is used.
Continuous Stock: If set to a value of 2, the printer will not activate the gap detector
circuit. After all fields are printed, the printer will advance the extra distance in the SPG
header element.
Normal Stock (leading edge): If defaulted (value of 0), the printer will detect the trailing
edge of the label (the beginning of the gap).
Black Line Stock: If set to a value of 1, the printer will detect the leading edge of a black
line.
Blow Hole Stock (Slot-Cut): Use the default value (0) and set software dip switch #4
(^D24) for blow hole stock (see section 5.3).