Emerson Radio PD5802 - Manual (Page 14)

1 3
LISTENING TO THE RADIO
1.) Press the POWER button on the main unit or the remote control. The main
display turns on and the STANDBY indicator goes “Off”.
2.) If necessary, press the FUNCTION button on
the top panel of the main unit or the remote
control to select the Tuner function. The display
will show an AM or FM station frequency. To
select a different band, press the STOP/BAND
button again.
3.) Tune to the desired frequency as follows:
• Manual Tuning
Repeatedly press the F.SKIP / R.SKIP buttons on the top panel of the main
unit or / buttons on the remote control until the frequency of the desired
station appears on the display.
• Automatic Tuning
Press and hold the F.SKIP / R.SKIP buttons on the top panel of the main unit
or / buttons on the remote control until the display begins to move, then
release the buttons. The tuner will search up or down the band for the next
strong station and stop on that station. Repeat this procedure until the tuner
stops on your desired station.
4.) Adjust the VOLUME, EQ and DBBS controls as desired.
5.) If you tuned to an FM Stereo station the ST indicator will appear in the main
display. If the reception is noisy or weak, switch the FM ST/MONO selector on
the back panel to select FM Mono mode. The ST indicator will disappear. The
reception will normally improve although the sound will no longer be in stereo.
6.) When you are finished listening press the POWER button on the main unit or
remote control to return to the Standby (Power Off) mode. The main display
goes off and the time display reappears.
PD5802_ib031803.p65 18/3/2003, 11:06 13