Epson 7850p - Manual (Page 88)

88 Presenting Through a Wireless Network
2. Make sure Location is set to Automatic .
3. Select Network Port Configurations in the Show pull-down
menu.
4. Under Port Configurations, select AirPort .
5. Click Apply Now . Then close the window.
6. Start the AirPort Admin utility. Select your base station, then
click Configure .
7. On the AirPort tab, make sure your AirPort network name
matches your projector’s ESSID. If not, enter the projector’s
ESSID in the AirPort Network text box and click
Update .
8. If you turned DHCP on in your projector’s advanced menu, click
the Network tab and make sure the Distribute IP addresses
check box is selected. If you need to select it, click Update .
Select
Automatic
Select Network Port
Configurations
then select AirPort
note:
If you don’t need the other
network ports, disable them
by deselecting their check
boxes. If more than one
network port is enabled, the
projector software warns you
to turn off AirPort when you
first connect the projector.
Disregard this message.
Your AirPort network and
base station names may be
different. To check or change
your AirPort network name,
start the AirPort Admin
utility, select your base
station, and click
Configure . Click Show All
Settings , then make any
changes you want on the
AirPort tab.
If you’re connecting to your
projector in static IP mode,
deselect the
Distribute IP
addresses check box. Make
sure your projector’s gateway
address is identical to the base
station’s IP address, and the
first three segments of the
projector’s IP address are
identical to the first three
segments of the base station’s
IP address.