Elmo HV-8000SX - Manual (Page 38)

- 37 -
Connection to the network
• Connection using HUB
Connect the Ethernet terminal (RJ-45) of the Presenter to the HUB port with an
Ethernet straight cable (UTP Category 5). For the HUB port, use a port other than
the cascade port.
• Connection to one host
Connect the Ethernet terminal (RJ-45) of the Presenter to the Ethernet terminal of
the host with an Ethernet cross cable (UTP Category 5).
RS-232C DC12V
MOUSE INPUT
S-VIDEO
VIDEO L AUDIO R
AUDIO
(L/R)2
ABCD
RGB OUT RGB2
RGB1
OUTPUT USB Ethernet
Ethernet cross cable (accessory)
Host
RS-232C DC12V
MOUSE INPUT
S-VIDEO
VIDEO L AUDIO R
AUDIO
(L/R)2
ABCD
RGB OUT RGB2
RGB1
OUTPUT USB Ethernet
Ethernet straight cable
Host
HUB
Host
Setting up of the network
• Start the Web browser from the host
connected to the Presenter.
• Enter the IP address or host name (if
allocated) of the Presenter, following
[http://], in the address column of the
Web browser provided for entering
the URL to be opened. For example,
enter the IP address of this Presenter
as “http://192.168.0.100/,” since it
has been factory set to 192.168.0.100.
• When the HV-800SX/8000SX/
8500SX page is displayed in the Web
browser, click the link [SET UP].
Note: Upon connection of this Presenter to other unit on the network through the
Ethernet terminal, the communication protocol is adjusted automatically
between the Presenter and the connected unit to 10BASE-T/100BASE-TX and
HDX/FDX (i.e., “automatic negotiation”). Therefore, this Presenter may not be
properly connected to some units on the network that do not comply with
automatic negotiation.