Electrolux 241857202 - Manual (Page 9)

9
DOOR REMOVAL / REVERSAL INSTRUCTIONS
To Remove Freezer Handle:
(Handles may be easier to reverse while doors
are off.)
1. Remove two screws attaching handle to
bottom of freezer door.
2. Remove short trim piece by sliding trim
straight up and off of handle bracket.
3. Remove screw attaching top of handle to
door.
4. Self-Adhesive Nameplate Models: Gently
peel off nameplate from door and reapply
over old handle holes.
To attach freezer handle:
1. Reinstall handle on opposite side, using
same hole as nameplate.
2. Attach handle to bottom of door.
3. Slide trim piece straight down onto handle
bracket.
To Remove Freezer Handle:
(Handles may be easier to reverse while doors
are off.)
1. Remove two screws attaching handle to
bottom of freezer door.
2. Remove button plug using edge of putty
knife.
3. Remove screw on side of freezer door and
remove handle.
Nameplate
Trim
Screw
Handle
Self Adhesive
Nameplate
(some models)
Screw
 NOTE
Some models have “pocket” handles, which are
recessed into the sides of the door. On these
models, only the hinges will need to be reversed.
Handle
Button
Plug
Screw
Screw
To attach freezer handle:
1. Secure side of handle to door and replace
button plug.
2. Secure handle to bottom of door.