Electrolux 241857202 - Manual (Page 12)

12
Shoulder
Screw
Set
Screw
Shoulder
Screw
Handle
Set
Screw
Screw
Handle
Button
Plug
Screw
Refrigerator Door Without Trim
To attach Refrigerator Handle:
1. Secure side of handle to door and replace
plug button.
2. Secure handle to top of door.
Removing Stainless steel Doors
and handles
To Remove Doors
Stainless steel doors are not reversible. Follow
these steps to remove doors.
1. Remove toe grille and top hinge cover.
2. Remove top hinge and lift freezer door off
of center hinge pin. Set door aside.
3. Unscrew center hinge bin using adjustable
wrench and save for reassembly. Ensure
plastic washer stays on hinge pin.
4. Lift refrigerator door off of bottom hinge
and set aside.
5. Remove center hinge and shim by
removing inside screw and loosening two
outside screws enough to allow hinge to
slide out.
6. Remove bottom hinge. Reinsert two
outside screws in holes and tighten.
7. Reverse steps 1 - 6 to reinstall doors
To Remove Handles
1. Firmly hold freezer handle while loosening
set screws with 3/32” allen wrench.
Remove freezer handle.
2. Repeat step 1 for refrigerator door.
DOOR REMOVAL / REVERSAL INSTRUCTIONS
To Remove Refrigerator Handle:
(Handles may be easier to reverse while doors
are off.)
1. Remove two screws attaching handle to
top of
refrigerator
door.
2. Remove
button plug
using edge of
putty knife.
3. Remove
screw on
side of
refrigerator
door and
remove
handle.
4. Reverse
freezer and refrigerator handles as shown in
figure 3.
Figure 3 - Handle Reversal

NOTE
Trim lock must be removed and installed by
sliding over the two donut shaped areas.
CAUTION
Use care when using tools near surface of
stainless steel doors to avoid scratching.