CHAUVET DJ Swarm Wash FX ILS Derby, Wash, Laser, Strobe, Multi-Effects Fixture - Manual (Page 24)

Page 17 of 125
Operation
Swarm Wash FX ILS User Manual Rev. 5
Configuration (Standalone)
Set the product in one of the standalone modes to control without a DMX controller.
Automatic Programs
To run the Swarm Wash FX ILS with an automatic program, follow the instructions below.
1. Press repeatedly until P-- shows on the display.
2. Press .
3. Use or to select the desired program, from P 1–15 . (see Programs )
4. Press .
5. Use or to select the program mode, from FAdE (fading) or SnAP (quick change).
6. Press .
Automatic Program Speed
To set the automatic program speed of the Swarm Wash FX ILS, do the following:
1. Press repeatedly until S-- shows on the display.
2. Press .
3. Use or to increase or decrease the speed, from S 1–99 (slow to fast).
4. Press .
Sound-Active Programs
To run the Swarm Wash FX ILS with a sound-active program, follow the instructions below.
1. Press repeatedly until Snd shows on the display.
2. Press .
3. Use or to select the desired program, from Sn 1–15 . (see Programs )
4. Press .
5. Turn the music on and adjust the sound sensitivity knob until the product starts responding to the
beat of the music.
Programs
Never connect a product that is operating in any standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX signals
that could interfere with the DMX signals from the controller.
• The product will only respond to low frequencies of music (bass and drums).
• The laser will black out when in Sound-Active mode after 3 seconds of silence or noise
below the sensitivity setting.
P--/Snd Effect
1 All effects
2 Wash only
3 Laser only
4 Swarm effect only
5 Strobes only
6 Wash, laser, and swarm effect
7 Wash, laser, and strobes
8 Wash, swarm effect, and strobes
9 Laser, swarm effect, and strobes
10 Wash and laser
11 Wash and swarm effect
12 Wash and strobes
13 Laser and swarm effect
14 Laser and strobes
15 Swarm effect and strobes