EverFocus SPEED DOME EPTZ1000 - Manual (Page 13)

2-12
- Video Cable
A BNC cable is used for connecting a speed dome to a DVR or a monitor. An amplifier
may be needed if the video cable is too long.
- Control Cable
Basically, EPTZ1000uses a differential pair to connect to other devices by cascading.
A cable that has low signal decline can be used as a control cable.
- Alarm Cable
An alarm cable is not included in the packing list. A suitable wire can be used as an
alarm cable.
2.3. Initial Setup
Initial setup includes dome address, communication protocol, transmission speed, video
format, and terminator resistance settings. All of the settings should be confirmed before
the dome is installed. The control-related setting that is address, communication protocol
and transmission speed have to be set consistently with the control device such as a
keyboard or a DVR.
Notice: Please make sure the power is off before setting, and restart the speed dome to
enable a new value after changing.