Epson WorkForce V-1100 - Manual (Page 67)

E-67
Replacing the Lamp Cartridge
PREPARATION Turn the projector upside down and place it on a soft cloth that has
been prepared in advance to prevent scratches. This will assist in lamp
cartridge replacement. After replacement, return the projector to the
original condition.
1.
Disconnect the power cable.
2.
Turn the projector upside down.
3.
Remove the lamp cover.
(1) Turn the screw that fastens the lamp cover
counterclockwise until it turns freely. (The screw
will not come out.)
(2) Lift the lamp cover a little and pull it off in the
direction of the arrow.
4.
Remove the lamp cartridge
(1) Turn the 2 screws that fasten the lamp cartridge
counterclockwise until they turn freely. (The
screws will not come out.)
(2) Grasp the handle of the lamp cartridge, pull it
upward and remove the lamp cartridge.