NEC M Series 32" Commercial PCAP Touchscreen Display - Manual (Page 63)

English−59
Commands
Connecting the monitor to a computer via RS-232C or to a network via LAN allows for the transmission of commands to the
monitor, providing remote control of the monitor from a connected device.
Instructions for each command format can be found in the external documents “External_Control.pdf”. See
page 69 .
RS-232C Interface
PROTOCOL RS-232C
BAUD RATE 9600 [bps]
DATA LENGTH 8 [bits]
PARITY NONE
STOP BIT 1 [bit]
FLOW CONTROL NONE
LAN Interface
PROTOCOL TCP
PORT NUMBER 7142
COMMUNICATION SPEED AUTO setting (10/100Mbps)
ASCII Control command
This monitor supports control command, which is listed in the “External_Control.pdf” (See page 69 ), but also supports
common ASCII control command, which is used for controlling the NEC monitor or projector from a connected computer.
For further information please visit our website.
NOTEN: If you turn off the monitor when [QUICK START] is [DISABLE], ASCII command control is not available over RS-232C.
To activate ASCII command control while the monitor is off, set [QUICK START] to [ENABLE].
Parameter
Input command Status command
Input signal name Response Parameter Response Error status
DisplayPort DisplayPort DisplayPort error:temp Temperature abnormal
HDMI1 hdmi1 hdmi1 or hdmi error:light Inverter or backlight abnormal
HDMI2 hdmi2 hdmi2 error:system System error
VGA vga vga
Media Player mp mp