Z CAM E2 4K Cinema Camera - Manual (Page 22)

2.9. Connect
• Network: there are sub - items as below:
n Wi - Fi : Off / On. When the Wi - Fi is activated, here will show the Wi - Fi ID, which
is ZCAM - E2 C - XXXX (last four digits which match to the camera ID), and the
default password is: 12345678 , which can only be changed with iOS app ( 6.
Using Z Camera App )
n Wi - Fi IP : Here will show IP address of the Wi - Fi when it’ s is activated.
n ETH. Mode (Ethernet Mode) : Direct / Router / Static
- Router : Camera is connected to the computer through a router, IP address will be
assigned by the router.
- D irect : Camera is connected to the computer directly through Ethernet cable, camera
will generate the IP address. The default is: 10.98.32.1
- Static : to set the IP address with configuration file. (Please contact Z CAM ’s technical
support if you want to set this)
n ETH. IP : IP address of the Ether net when it’s connected.
•
USB : Host / Mass Storage / Network / Serial
n Host : The camera will act as a host devic e which can transfer data to external storage
(SSD e.g.) or communicate with external device like iOS device with Z Camera app
( 6. Using Z Camera App ).
n Mass Storage : The camera will be recognized as a s torage when it is connected to
a computer (PC / Mac), and the file on the SD card inside the camera can be accessed.
n Network : The camera will act as a RNDIS device.
The camera will be recognized as a RNDIS device when it is connected to a computer
(PC / Mac) or external device. C omputer or external device can access or control the