Electrolux 63742 VI - Manual (Page 40)

40 Installation
When discharging into a standpipe
ensure that the top of the standpipe is
no more than 90 cm (35.4'') and no less
than 60 cm (23.6'') above floor level.
The drain hose may be extended to a
maximum of 4 metres. An additional
drain hose and joining piece is available
from your local Service Force Centre.
The joining piece must have an internal
diameter of 18 mm.
If your drain hose looks like this (see the relevant
picture) you do not require the “U” piece”. Just push
the hose firmly into the standpipe.
2. Onto a sink outlet spigot.
If the outlet spigot has not been used before, remove any blanking plug that may
be in place.
Push the drain hose onto the spigot and secure with a
clip, ensure a loop is formed in the drain hose (see dia-
gram) to prevent waste from the sink entering the
washing machine.
The drain hose may be extended to a maximum of 4
metres. An additional drain hose and joining piece is
available from your local Service Force Centre. The
joining piece must have an internal diameter of 18
mm.
If you intend to drain the hose from the machine into
a sink, make sure that the sink is empty and the plug
hole is not blocked. Use the plastic “U -Piece” supplied.
3 pin
M
ax
. 90
cm
.
(35
.4")
Mi
n.
60
cm
.
(23
.6")
Loop
132963770_en.qxd 21/07/2008 8.25 Page 40