Electrolux 63742 VI - Manual (Page 19)

Cancelling a programme
Turn the selector dial to O to cancel a programme which is running. You can
now select a new programme.
Opening the door after the programme has started
First set the machine to pause by pressing the button 8 . If the pilot light 10.2
blinks some minutes and then goes off, the door can be opened.
If the DOOR remains locked the pilot light 10.2 is on, this means that the
machine is already heating, that the water level is too high. In this case the door
can not be opened. If you cannot open the door but you need to open it you
have to switch the machine off by turning the selector dial to
O . After some
minutes the door can be opened (pay attention to the water level and
temperature!).
After closing the door, it is necessary to select the programme and options again
and to press the button
8 .
At the end of the programme
The machine stops automatically, the pilot light of the button 8 , the pilot lights
10.1 and 10.2 go off and a blinking 0 will appear on the display.
If a programme or an option that ends with water still in the tub has been
selected, the pilot light
10.2 illuminates, a blinking 0 will appear on the display,
the pilot light of the button 8 goes off and the door remains locked to indicate
that the water must be emptied out before opening the door.
Follow the below instructions to empty out the water:
● turn the programme selector dial to O
●
select the DRAINING or SPINNING programme
● reduce the spin speed if needed, by means of the relevant button
● press button 8
● when the programme has finished the display shows a blinking 0 . The pilot light
10.2 goes off and the door can be opened.
Turn the programme selector dial to O to switch the machine off. Remove the
laundry from the drum and carefully check that the drum is empty. If you do not
intend to carry out another wash, close the water tap. Leave the door open to
prevent the formation of mildew and unpleasant smells.
19 Use
132963770_en.qxd 21/07/2008 8.25 Page 19