HP Z38c 37.5" 21:9 Curved IPS Monitor (Smart Buy) - Manual (Page 12)

Mounting the monitor
The monitor panel can be attached to a wall, swing arm, or other mounting fixture.
NOTE: This apparatus is intended to be supported by a UL- or CSA-Listed wall mount bracket.
CAUTION: This monitor supports the VESA industry-standard 100 mm mounting holes. To attach a third-
party mounting solution to the monitor, four 4 mm, 0.7 pitch, 10 mm long screws are required. Longer screws
must not be used because they may damage the monitor. It is important to verify that the manufacturer’s
mounting solution is compliant with the VESA standard and is rated to support the weight of the monitor
display panel. For best performance, it is important to use the power and video cables provided with the
monitor.
Removing the monitor stand
CAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and all cables are
disconnected.
Do not lay the monitor facedown when removing the stand. Stress on the curvature of the display panel may
damage the panel if the monitor is placed facedown.
1. Disconnect and remove all cables from the monitor.
2. Place the monitor on a level surface with the bottom of the stand facing up.
CAUTION: The screen is fragile. Avoid touching or applying pressure to the screen; doing so can cause
damage.
3. Press down on the release latch (1) and tilt the stand base away from the monitor (2).
4. Disengage the hooks at the top of the stand and lift the stand away from the monitor (3).
6 Chapter 1 Getting Started