HP Z38c 37.5" 21:9 Curved IPS Monitor (Smart Buy) - Manual (Page 11)

Setting up the monitor
To set up the monitor, ensure that the power is turned off to the monitor, computer system, and other
attached devices, then follow the instructions below.
NOTE: Be sure the master power switch, located on the rear panel of the monitor, is in the Off position. The
master power switch turns off all power to the monitor.
Use caution when setting up the monitor
To prevent damage to the monitor, do not touch the surface of the LCD panel. Pressure on the panel may
cause nonuniformity of color or disorientation of the liquid crystals. If this occurs the screen will not recover
to its normal condition.
Attaching the monitor stand
CAUTION: The screen is fragile. Avoid touching or applying pressure to the screen; doing so can cause
damage.
Do not lay the monitor facedown when attaching the stand. Stress on the curvature of the display panel may
damage the panel if the monitor is placed facedown.
TIP: Consider the placement of the display, because the bezel might cause interfering reflections from
surrounding light and bright surfaces.
1. Remove the stand from the box.
2. Insert the hooks at the top of the stand plate into the holes (1) on the back of the monitor.
3. Rotate the stand base up and toward the monitor (2) until the stand plate clicks into place.
Setting up the monitor 5