beautypg.com

Lowpass gate, Modules in the pico system iii – Erica Synths Pico System III Eurorack Modular Synthesizer System (Eurorack Module) User Manual

Page 9

background image

BBD

TIME

FBK

TIME CV

IN

OUT

DRY/WET

Use this knob to adjust VCF cutoff and VCA bias

manually. Incoming CV is added to the knob

setting

Adjust the resonance of the LPG circuit. Far CW

settings put the LPG in self-resonance, and it

can be used as a sound source

NB! it can get very loud!

These are the VCF cutoff/VCA bias CV inputs,

only CV2 is routed to the voicecard

Select between VCF and VCA modes! By default

the VCF has some preset resonance.

Patch an audio signal here

This is the LPG output

LPG1

OFFSET

RESO

CV1

CV2

IN

OUT

VCA

VCF

LOWPASS GATE

is our take on classical Don Buchla LPG designs.

We use vactrols in the circuit for that signature

sound, and we added resonance control of the

LPG circuit. When resonance is full CW, the module

goes into self-oscillation and can be used as a

sound source.

Adjust the Delay time from very short, flanger-like effects

CCW to nice analogue delay effects and extreme sonic

artefacts CW. The Time CV is added to the knob setting

Adjust feedback level! In full CW setting the module will go

to self oscillation

This is the Dry/Wet crossfade control

This is feedback filtering switch. At right most position you

will get authentic, unfiltered, bit noisy BBD sound, other

settings filter off noise, and the signal in feedback is

cleaner, but misses higher harmonics

This is time CV input

Patch the audio signal here

This is the output of the module

BBD

is full analogue 4092 stage bucket brigade delay

module. Besides nice and clean flanger and delay

effects, at full CV settings of TIME and feedback

knobs it can produce extreme sonic artefacts.

Tweak knobs and enjoy!

MODULES IN THE PICO SYSTEM III

Adjust the tune of the VCO manually! 1V/oct CV is added to

the setting of this knob

Adjust waveshape available on the SHAPE output manually!

SHAPE CV is added to the setting of this knob

Three position switch allows you to transpose the pitch of

the VCO one octave up or down

Patch the sequencer or any FM source here

This is Waveshaper CV input. Experiment with different

modulation sources to get drones, rhythmic patterns and

fat analogue sound

This is Waveshaper wave output

This is gentle sounding Triangle wave output