Erica Synths Pico System III Eurorack Modular Synthesizer System (Eurorack Module) - Manual (Page 6)

VCO1
TUNE
PWM
1V/OCT
PWM CV
PULSE
TRI
+1OCT
-1OCT
SEQ
CLK IN
2 4
CV OUT
The SEQUENCER
is straight-forward, full analogue 2-3-4 step
sequencer/waveshaper with adjustable sequence
length. Particularly interesting use of the SEQ2
is waveshaping – just apply any audio source to
the CLK IN, tweak the knobs and be amazed!
VCO1
is powerful, full analogue VCO with great
tracking over 8 octaves with simultaneous
triangle and pulsewave outputs, pulse width
modulation and exponential frequency modulation.
It sounds like real analogue beast!
MODULES IN THE PICO SYSTEM III
Use these knobs to set the voltages per step. LEDs will
give visual feedback on the currently active step. If you
apply the audio signal to the input, the sequencer will act
as a waveshaper, where the signal is converted into (up to)
4 step “staircase” with adjustable step height. This way you
can create a suboscillaors and plenty of other distinct
sounds that are in tune with your audio source.
Select a number of steps (2-3-4) in the sequence!
Patch the clock or audio signal here. Due to limited panel
space and functionality, Pico SEQ2 does not have a Gate
output. We recommend you to use stackable patchcables
to copy clock signal to envelope generators OR get gates
from Pico Trigger or Logic modules
This is the CV output
Adjust the tune of the VCO manually! 1V/oct CV
is added to the setting of this knob
Adjust Pulse Width manually! PWM CV is added
to the setting of this knob
Three position switch allow you to transpose
the pitch of the VCO one octave up or down
Patch the sequencer or any FM source here
This is PWM CV input. Experiment with different
modulation sources to get drones, rhythmic
patterns and fat analogue sound
This is Pulse wave output
This is gentle sounding Triangle wave output