Erica Synths EDU DIY Wavefolder Eurorack Module Kit User Manual

Page 51

Now, turn the PCB around and inspect

your solder joints. Make sure all

components are soldered properly and

there are no cold solder joints or

accidental shorts. Clean the PCB to

remove extra flux, if necessary.

Insert the jack sockets and solder them.

Then insert the potentiometer, but don’t

solder it yet! Fit the front panel and make

sure that the potentiometer shaft is

aligned with the holes in the panel – and

that they’re able to rotate freely. Now, go

ahead and solder the potentiometer.

Then fit the front panel and fix it with the hex

nuts.

Now, insert the IC into the DIP socket.

Mind the orientation of the IC – match the

notch on the IC with the one on its socket.