Erica Synths EDU DIY Wavefolder Eurorack Module Kit User Manual

Page 49

In order to save space on the PCB, some of our projects, including the Wavefolder,

have vertically placed resistors. The next step is to place & solder those. All

components on the PCB have both their value and denomination printed onto the

silkscreen. If you are not sure about a resistor’s value, use a multimeter to

double-check. Bend a resistor’s legs so that its body is aligned with both legs and

insert it in its designated spot. Then solder the longer lead from the top side of the PCB

to secure it in place, turn the PCB around and solder the other lead from the bottom.

You can insert several resistors at once. Once done with soldering, use pliers to cut off

excess leads.

Once you are done with soldering all

resistors, your PCB should look like this: