beautypg.com

Erica Synths EDU DIY Wavefolder Eurorack Module Kit User Manual

Page 48

background image

Place the Mixer PCB in a PCB holder for

soldering or simply on top of some spacers

(I use two empty solder wire coils here).

I usually start populating PCBs with lower,

horizontally placed components. In this case,

these are power protection diodes. Bend

the diode leads and insert them in the rele-

vant places according to the part

placement diagram above. Remember –

when inserting the diodes, orientation is

critical! A thick white or black stripe on the

PCB indicates the cathode of a diode –

match it with the stripe on the component.

Flip the PCB over and solder all components.

Then, use pliers to cut off the excess leads.

Next, insert the DIP socket, hold it in

place and solder one of the pins. Make sure

the DIP socket is oriented correctly – the

notch on the socket should match the notch

on the PCB’s silkscreen. Now, turn the PCB

around and solder all remaining pins of the

DIP sockets. Then proceed with the

ceramic capacitors. Place the PCB in your

PCB holder or on spacers, insert the

capacitors and solder them like you did with

the diodes before. After this procedure

PCB should look like this:

48