Echo PRO ATTACHMENT SERIES PAS-225 User Manual

Page 8

1. POWER hEAD - Includes the Engine, Clutch, Fuel System, Ignition System and Recoil Starter.
2. GRIP - Rear (right hand) handle.
3. ThROTTLE TRIGGER LOCKOUT - Operation of the throttle trigger is prevented unless throttle trigger lockout

lever is engaged.

4. STOP SWITCh - "SLIDE SWITCH" mounted on top of the Throttle Trigger Housing. Move switch FORWARD to

RUN, BACK to STOP.

5. FRONT hANDLE - The front (loop) handle must be assembled to the Upper Drive Shaft Assembly (some models)

and must be positioned for proper cutting attitude and operator comfort.

6. UPPER DRIVE ShAFT ASSEMbLy - Includes the Rear (Right Hand) Grip Assembly, Front (Left Hand) Handle

Assembly, Upper Flexible Drive Cable, Drive Shaft Assembly Coupler and Power Head.

7. DRIVE ShAFT COUPLER - Includes Locator Pin and Clamping Knob.
8. ThROTTLE TRIGGER - Spring loaded to return to idle when released. During acceleration, press trigger gradu-

ally for best operating technique.

9. TOP GUARD - Protects arm from the hot engine.
10. SPARK ARRESTOR MUFFLER OR SPARK ARRESTOR MUFFLER WITh CATALyST -The muffler or

catalytic muffler controls exhaust noise and emission. The spark arrestor screen prevents hot, glowing particles of
carbon from leaving the muffler. Keep exhaust area clear of flammable debris.

11. FUEL TANK - Contains fuel and fuel filter.
12. I-30 RECOIL STARTER/hANDLE - i-30 spring-assisted recoil starter requires 30% less pulling force than

standard recoil starter. Pull handle slowly until starter engages, then quickly and firmly. When engine starts, return
handle slowly. DO NOT let handle snap back or damage to unit will occur.

13. FUEL TANK CAP - Covers and seals fuel tank opening.
14. PURGE bULb - Pumping purge bulb before starting engine draws fresh fuel from the fuel tank, purging air from the

carburetor. Pump purge bulb

15. AIR CLEANER - Contains replaceable filter element.
16. ChOKE - Adjusts Fuel/Air ratio for starting or running engine. The choke control is located at the top of the air filter

case. Move choke lever to "Cold Start" (

) to close choke for cold starting. Move choke lever to "Run" (

) posi-

tion to open choke.

17. SPARK PLUG - Provides spark to ignite fuel mixture.