Echo PRO ATTACHMENT SERIES PAS-225 - Manual (Page 15)

P
ro
A
ttAchment
S
erieS
tm
o
PerAtor
'
S
m
AnuAl
15
m
aIntenanCe
wArning
Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all
openings. Always stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop
before removing obstructions, clearing debris, or servicing unit. Allow unit to cool before performing service. Wear
gloves to protect hands from sharp edges and hot surfaces.
Your ECHO unit is designed to provide many hours of trouble-free service. Regular scheduled maintenance will help
your unit achieve that goal. If you are unsure or are not equipped with the necessary tools, you may want to take your
unit to an ECHO Service Dealer for maintenance. To help you decide whether you want to DO-IT-YOURSELF or have
the ECHO Dealer do it, each maintenance task has been graded. If a task is not listed, see your ECHO Dealer for repairs.
skIll levels
Level 1 = Easy to do. Common tools may be required.
Level 2 = Moderate difficulty. Some specialized tools may be required.
ECHO offers REPOWER TM Maintenance Kits and Parts to make your maintenance job easier.
coMPonenT / SYSTeM MAinTenAnce Procedure
reQ'd
SKiLL
LeVeL
dAiLY or
BeFore
uSe
eVerY
reFueL
3 MonTHS
or 90
HourS
YeArLY 600
HourS
Air Filter Inspect/Clean 1 I / C * R*
Choke Inspect/Clean 1 I / C
Fuel Filter Inspect 1 I * I / R *
Fuel Cap Gasket Inspect/Replace 1 I * R *
Fuel System Inspect/Replace 1 I (2) * I (2) *
Spark Plug Inspect/Clean 1 I / C / R *
Cooling System Inspect/Clean 2 I / C
Muffler Spark Arrestor Inspect/Clean/Replace 2 I / C / R *
Cylinder Exhaust Port Inspect/Clean/Decarbon 2 I / C
Drive Shaft Grease 2 I (1)
Recoil Starter Rope Inspect/Clean 1 I / C *
Screws/Nuts/Bolts Inspect/Tighten/Replace 1 I *
MAinTenAnce Procedure LeTTer codeS: i = inSPecT, r = rePLAce, c = cLeAn
iMPorTAnT noTe - Time intervals shown are maximum. Actual use and your experience will determine the
frequency of required maintenance.
MAinTenAnce Procedure noTeS:
(1) Apply POWER BLENDX
TM every 25 hours of use.
(2) Low evaporative fuel tanks DO NOT require regular maintenance to maintain emission integrity.
* All recommendations to replace are based on the finding of damage or wear during inspection.
m
aIntenanCe
I
ntervals