Roland UM-ONE mk2 - In-Line USB MIDI Interface - Manual (Page 18)

18
Troubleshooting
If you experience problems, read this chapter first. It contains tips for solving most problems. If this
chapter cannot help you solve a problem, please refer to the support section of our website. If the
problem is not resolved, refer to the contact information listed at the end of this document.
Roland support website: http://www.roland.com/
Driver Installation
Problem Confirmation Resolution
Installer does not
start
Are you attempting to install from a
networked CD-ROM drive?
You cannot install from a networked CD-ROM drive.
Cannot install
Are you logged on with a user account
that does not have administrator
privileges?
Log on to the computer with a user account that
has administrator privileges.
For details, consult the administrator for your
computer system.
Is the “Driver Signing Options” setting set
to [Block]? (Windows XP)
Change the “Driver Signing Options” setting (p. 22).
Are other programs or resident
programs (such as antivirus programs)
running?
Be sure to exit all other programs before
installation.
Warning or
error appears
during installation
(Windows)
In the “Device Manager,” do you see
“Other device,” “Unknown device,” or a
device for which “?,” “!,” or “x” is displayed?
Reinstall the UM-ONE driver (p. 23).
Installer does not
exit
Is your computer running on battery
power?
Connect the power cord to the computer.
Other than a mouse and keyboard, are
any USB devices connected?
Make sure that there are no USB devices
connected to the computer (other than a mouse
and keyboard) during installation.
Is the UM-ONE connected to a USB hub
that is connected to a power supply?
Use a USB hub that connects to a power supply.
“Found New
Hardware Wizard”
appears again after
driver was installed
(Windows XP)
Did you connect the UM-ONE to a
different USB connector than the one
you used when installing the driver?
If you change the USB connector to which the
UM-ONE is connected, the “Found New Hardware
Wizard” may appear again even if the driver has
already been installed on the computer.
Follow step 9 of the driver installation procedure (p.
11) and install the driver.