Roborock S4 Max - Manual (Page 20)

19
Installation
Using the robot
1. Place the charging dock against the wall on a flat surface and
plug it into the mains power.
2. Secure the charging dock with the adhesive tape. Wipe the floor
of the area where the charging dock will be placed with a dry
cloth, then stick the enclosed double-sided tape to the floor.
Place the dock onto the double-sided tape to secure it in place.
3. Power on and charge.
Press and hold the button to turn on the robot. When the
power indicator lights up, place the robot onto the charging
dock to begin charging. The robot uses a high-performance
lithium-ion rechargeable battery. To maintain peak battery
performance, always keep the robot charged.
The color of the power
indicator indicates the
battery level
• White: Battery level
≥
20%
• Red: Battery level < 20%
Note:
• The charging dock should have more than 0.5m (1.6ft) of clearance on each side,
and more than 1.5m (4.9ft) in the front.
• If the power cable is vertical to the ground, it may be caught by the robot, causing
the charging dock to be disconnected.
• The charging dock indicator is on when the charging dock is electrified, and off
when the robot is charging.
Note:
The robot will not turn on when the battery is low. Place the robot directly onto the
charging dock to begin charging.
Note:
• Use of the double-sided tape to secure the charging dock is optional.
• When necessary, remove the double-sided tape slowly to reduce residue glue.
More than 1.5m
(4.9ft)
More than 0.5m
(1.6ft)
More than 0.5m
(1.6ft)
Double-sided
tape