ProSoft Technology AN-X-AMX - Manual (Page 21)

AN-X-DCSNet2 Page 17
DCSNet Configuration
You set the DCS mode of operation (master or slave) and the drop
number and depth using the web interface.
Start your web browser and enter the AN-X IP address as the address.
Select Automation Network/DCSNet Configuration to set the DCS drop
number and depth.
AN-X-DCSNet can be used as a DCS master or slave. Check Master or
Slave
to select which one you want.
If the AN-X-DCSNet is a DCS slave, enter the Drop Number and Drop
Depth
. These entries are ignored if the AN-X is a DCS master.
Click the SUBMIT button to send the values to AN-X.
AN-X defaults to DCS slave operation with drop number 55 and drop
depth 1.
For further details, refer to page 48.