ProSoft Technology AN-X-AMX - Manual (Page 12)

Page 8 AN-X-DCSNet2 November 2011
AN-X is using this temporary IP address, it repeatedly flashes the SYS
LED three times followed by a pause.
IMPORTANT!
Use this temporary IP address only for initial setup of AN-X. AN-X will
not function for its intended purpose at the temporary IP address.
If you are using multiple AN-X modules, configure one at a time,
especially if there is no DHCP server on the network, since they will all
revert to the same temporary IP address when they fail to find a DHCP
server.
IMPORTANT!
If you are connecting AN-X to an existing Ethernet network, consult the
network administrator to obtain a static IP address for AN-X and to
obtain other information about how you should configure AN-X.
IMPORTANT!
The AN-X must be on the local Ethernet (same subnet as the computer)
when you set its IP address.
You configure the Ethernet properties using the Windows utility AnxInit
supplied with AN-X. You can also set the IP address through the web
interface. Refer to page 55
Use the Configuration/AN-X IP Settings command to start the AN-X IP
configuration wizard, which takes you step by step through the IP
configuration process.
Step 1
In step 1, you identify the AN-X you are configuring.