PLANET ICA-HM120 - Manual (Page 12)

2.3 Hardware Installation
2.3.1 Camera Mounting
Step 1. Attach the IP camera with the included stand.
Step 2. Fix the IP camera to ceiling with the three supplied supplied screws.
Fixed Camera
by Screws
Step 3. Connect an Ethernet cable to the LAN socket located on the camera’s rear and attach it
to a switch or hub. When this switch/hub is a PoE device, you can ignore the next step.
Step 4. Connect the attached power adapter to the DC power jack of the camera.
NOTE:
Use the power adapter, 12VDC, included in the package and connect it to wall outlet for
AC power.
Step 5. Once you have installed the camera well and powered it on, the power LED (orange) will
turn on later. The power LED turned on, it means the system is booting up successfully.
Furthermore, if you have a proper network connection, and access to the camera, the
network active LED (green) will flash.
NOTE:
1. Only use the power adapter supplied with IP camera Otherwise, the product
may be damaged.
2. The power adapter is unnecessary when IP camera is connected to a
IEEE802.3af PoE switch. Otherwise, the product may be damaged when IP
camera is connected to a PoE switch and power adapter simultaneously.
11