PLANET ICA-BOX30 - Manual (Page 4)

4. Fix the camera on the slide
board by screw and washers.
(The sample is PLANET ICA-750.
You may adjust the numbers of
washer to make the camera
higher or lower to fit the
ICA-BOX30.)
5. Put the slide board with the fixed
camera back to the track of
housing, and connect the output
power cable to the power-in
connector of camera.
6. Refer to camera’s manual to
deploy the other cables to
connect to the camera inside.
(Ethernet, power, video, audio cables etc…)
Note:
1. Before connecting power to IR board and controller
of heater/fan, please make sure the power output
voltage is DC 12V (max. ±10%), 1.5A.
2. Power connector information of the controller:
7. Turn the water proof ring tightly
when the cables are arranged
properly.