PLANET ICA-151 - Manual (Page 6)

2.3 Physical Installation
1. Connect an Ethernet cable
Connect one end of an Ethernet cable to the LAN port located on the IP camera’s
rear panel and connect the other end to the network device (hub or switch).
2. Attach the external power supply
Attach the provided power adapter to the IP camera’s connector labeled “PWR”
on the rear panel.
3. Check the LEDs
a. The Power LED will turn on briefly, and then start blinking during startup.
After startup is completed, the Power LED will remain ON.
b. The LAN LED will be ON.