PLANET ICA-100C - Manual (Page 6)

4
3. Check the LEDs
The PWR and ACT LEDs should be on.
Physical Installation of ICA-100C-V2
Configuration
The Internet Camera contains an HTTP server. This enables you to connect and configure
it using your Web Browser.
Preparation
Before attempting to connect the Internet Camera, please ensure that:
• The Internet Camera must be installed and powered ON.
• If the Internet Camera’s default IP Address (192.168.0.20) is already used by
another device, the other device must be turned OFF until the Internet Camera
is allocated a new IP Ad-dress during configuration.
• Your PC can establish a physical connection to the Internet Camera. The PC
and the Internet Camera must be directly connected (using the LAN port on
the Internet Camera) or on the same LAN segment. That is, the PC must be
configured to an IP address and subnet mask in 192.168.0.x segment. For
example: IP: 192.168.0.2, subnet mask: 255.255.255.0.
Connecting to the Internet Camera
To establish a connection from your PC to the Internet Camera:
1. Installing the Internet Camera in your LAN.