PLANET WNL-U554A - Manual (Page 35)

150Mbps 802.11n Wireless USB Adapte r
WNL‐U554A
‐ 35 ‐
wish to connect.
This is a
computer-to-computer
(ad-hoc) network Check this box if you wish to connect to another computer/
network device by ad-hoc method. When not accessing to
wireless access point, you have to check this box.
Channel
Select wireless channel for ad hoc connection. This option
only appears when you’re using ad-hoc connection.
Network authentication
Select the network authentication type from drop-down menu.
This setting must be identical with the setting of wireless
access point you wish to connect.
Data encryption
Select the data encryption type from drop-down menu. This
setting must be identical with the setting of wireless access
point you wish to connect.
ASCII / PASSPHRASE
When the encryption type is “WEP”, it’s required to input a set
of “passphrase” to connect to wireless access point. Checking
“ASCII” or “PASSPHRASE” depends on the security setting of
access point, and inputting it in the box; if you select
“PASSPHRASE”, you also need to select the length of the
key.
The passphrase must be identical with the setting of wireless
access point you wish to connect.
Key index
Select WEP key index. For most of access points you can
select “1”, but please refer to the setting of the access point.
Network key / Confirm
network key
When the encryption type is “WPA” or “WPA2-PSK”, it’s
required to input a set of “passphrase” to connect to wireless
access point. Please input the same passphrase in two boxes
for confirmation.
EAP TYPE / Tunnel /
Provision Mode
When authentication type is any of 802.1X, you have to select
EAP type, tunnel, and provision mode from dropdown menu.
This setting must be identical with your 802.1x authentication
server.
Username / Identity /
Domain / Password Please input 802.1x related authentication information here.
Certificate
If certification is required to authenticate with 802.1x
authentication server, please select a local certificate from
dropdown list.
PAC
Check this box and PAC (Privilege Access Certificate) will be
automatically selected.
When all required parameters are set, click “OK” to create and save a new profile.
4.1.2 Remove an existing profile
If you want to remove a profile no longer needed, click “Profile” label, and then select the existing
profile you wish to remove, and click “Remove” button.