PLANET WNRT-300 - Manual (Page 5)

5
3. Hardware Installation
Note
Before you start using the portable router,
please follow the procedures below to
install and charge the battery.
Step 1: Remove the battery cover, and insert the
attached battery into the slot. Then replace
the cover back.
Step 2: Charge the battery by the attached power
adapter and USB cable.
Step 3: The red LED will be lit up. When the
battery is fully charged, the LED will be off.
Note
If you will use the WNRT-300 powered by
AC power supply for a long time, please
remove the battery from the slot and keep
it of full power in a cool and dry place.
Please follow the instructions below to activate the
WNRT-300.
STEP 1: When the battery is put into the device, turn
on the WNRT-300.
RT/Client/AP ON/OFF WPS