PLANET WNAP-7350 - Manual (Page 21)

User Manual of WNAP-7350
-14-
3.3 Installing the AP
Please install the AP according to the following steps. Don't forget to pull out the power plug and keep your
hands dry.
Step 1. Plug the N-Type (M) to N-Type (M) RF cables into the antenna connectors of the WNAP-7350, and
then connect the N-Type (F) antennas to the other side of the RF cables.
Figure 3-1
Step 2. Plug the RJ-45 Ethernet cable into the LAN Port of WNAP-7350 through the waterproof kit.
Figure 3-2
Step 3. Take out the power cord and PoE injector, plug the power cord into the DC port and plug the other side
of the RJ-45 cable into the POE port of the PoE injector.
Figure 3-3
Step 4. Plug the other waterproof kit to the WAN/LAN port to complete the installation.