PLANET WNAP-7200 - Manual (Page 16)

3. GETTING STARTED
The WLAN CPE is delivered with the following factory default parameters on the Ethernet
LAN interfaces.
Default IP Address: 192.168.0.1
Default IP subnet mask: 255.255.255.0
WEB login User Name: admin
WEB login Password: admin
The device has multiple operation modes (Bridge / Gateway / WISP). The default mode is
Bridge mode and the default IP addresses for the device are 192.168.0.1, so you need to
make sure the IP address of your PC is in the same subnet as the device, such as
192.168.0.2~254.
Note: It will take about 40 seconds to complete the boot up sequence after power on.
Default IP address of WISP mode:
Default IP Address: 172.32.1.254
Default IP subnet mask: 255.255.255.0
So you need to make sure the IP address of your PC is in the same subnet as the device,
such as 172.32.1.1~253.
The system will prompt the message when you change the operating mode to WISP.
16