PLANET VC-202A - Manual (Page 28)

2
3.3.2 Connecting Multiple PCs to an Ethernet LAN
Refer to the following procedures to setup the VC-202A to an
Ethernet LAN.
1. Set the VC-202A to be CO or CPE mode from the DIP switch
at the rear panel.
2. Power on the VC-202A by connecting its power source.
3. Power LED will illuminate.
4. Connect coaxial cable from another VDSL device to VDSL BNC
port of the VC-202A.
5. LNK LED will illuminate.
6. Connect Ethernet port to Ethernet Switch (or Broadband
Router) via regular Cat. 5, 5e or 6 cables.
VC-202A
VDSL
BNC
Fast Ethernet
Switch
RG58 Jack
RJ-45
Cat.5 Twisted Pair Cable
RG58 / RG6
TP
b/g b/g
VDSL2
100Base-TX UTP
VDSL2 Coaxial Cable VDSL2
Figure 3-7: Connecting Multiple PCs to an Ethernet LAN
Note
Please refer to your Ethernet device User’s Manual
for the device’s set up information.