PLANET GTP-80x Series - Manual (Page 13)

13
If one of the optical conductors is down (as shown in the
diagram box below), the converter with LLR function will return
a no-link condition to its link partner. With LLCF function also
enabled, the no-link condition is carried forward to the switch/
hub where a trap is generated to the management station, and
the administrator can then determine the source of the loss.
Media
Converter
Management
Station
Switch/Hub
w/SNMP
Station
Media
Converter
Switch/Hub
Fiber
Cable
LFP OFF LFP ON
l LED lit = established link ° LED unlit = no link
Media
Converter
Management
Station
Switch/Hub
w/SNMP
Station
Media
Converter
Management
Switch/Hub
TP TP
Broken
Fiber
LFP ON LFP ON
l LED lit = established link ° LED unlit = no link
Port 2 Port 1
Link Loss Carried Forward
Link Loss Returned
Link Loss Carried Forward
Note
LFP function is turn-off in default. This feature
can also be turned via the side DIP-switch. If
you are not familiar with the network installa-
tion and for diagnostic purpose (i.e. check which
end is broken), you can turn it on and reset the
converter to make it take effect. Otherwise, please
remain it in the default position.