PLANET FT-807 - Manual (Page 7)

3
1.5 Duplex Mode Setting
The TP port of FT-807 supports duplex mode detection by auto-
negotiation (A-N). The following is the duplex mode parameters:
Fast Ethernet Device
FT-807 Duplex Mode Sup-
port
Ethernet/Fast Ethernet
Hub
Half-Duplex
Ethernet / Fast Ethernet
Switch (without A-N)
Half-Duplex
Fast Ethernet Devices *
Support Auto-Negotiation
Full-Duplex/Half Duplex

NOTE:
Normally, an A-N switch will detect and set to
full-duplex, where a dual-speed hub will detects
half.
The fiber port (POF) port of FT-807 is fixed at 100Mbps full-duplex
mode. The link partner should also set at 100Mbps full-duplex
mode at the same time.
1.6 Power information
The power jack of FT-807 is with 2.5mm in the central post
and required +5VDC power input. Should you have the issue to
make the power connection, please contact with your local sales
representative.
Chapter 2 Installation
Please follow these steps to install the converter:

Turn off the power of the device/station in a network to
which the FT-807 will be attached.

Ensure that there is no activity in the network.

Attach POF fiber cable with SMI type connector from the