PLANET FT-1105A User Manual
Page 12

9
Step 2: Carefully slide in the module until it is fully and firmly
fitted into the slot of the chassis.
Figure 6-2: Insert a media converter into an available slot
Step 3: Attach a rack-mount bracket to each side of the Chassis
with supplied screws attached to the package.
Step 4: After the brackets are attached to the chassis, use suitable
screws to securely attach the brackets to the rack, as
shown in Figure 6-2.
Step 5: Proceed with the steps 4 and steps 5 of session 6.1 Stand-
alone Installation to connect the network cabling and
supply power to your switch.
Caution:
You must use the screws supplied with the mounting
brackets. Damage caused to the parts by using
incorrect screws would invalidate your warranty.
This manual is related to the following products: