PLANET IGS-10020HPT - Manual (Page 10)

10
4. Terminal Setup
To configure the system, connect a serial cable to a COM port on a PC or
notebook computer and to RJ45 type serial (console) port of the Managed
Industrial Switch. The console port of the Industrial Managed Switch is DCE
already, so that you can connect the console port directly through PC without the
need of null modem.
PC / Workstation
with
Terminal emulation software
RJ45 to DB9 RS-232 Cable
Serial Port
IP Address:
192.168.0.100
IGS Industrial Managed Switch
A terminal program is required to make the software connected to the IGS
Industrial Managed Switch. Windows’ Hyper Terminal program may be a good
choice. The Hyper Terminal can be accessed from the Start menu.
1. Click START, then Programs, Accessories and then Hyper Terminal.
2. When the following screen appears, make sure that the COM port should be
configured as:
 Baud : 115200
 Parity : None
 Data bits : 8
 Stop bits : 1
 Flow Control : None